dogbertwrldrulr wrote:I cant figure out for the life of me whats wrong. When installing the driver, its built from source (oss-v4.2-build2003-src-gpl).
dogbertwrldrulr wrote:Attached is the output of ossinfo -v3. I attempted to record using the /dev/oss/oss_envy24/pcmin0 device with the same error.
M Audio Delta 1010LT in1 /dev/oss/oss_envy240/pcmin0 (device index 0)
Legacy device /dev/dsp0
dogbertwrldrulr wrote:I dont think that I can switch the mode. The devices are setup during the driver install. I typically try to record with the /dev/dsp# (we have to support older systems so we use the legacy links). The only thing I am aware that I can do is to swap if the inputs come before the outputs (in oss_envy24.conf), but that only changes the /dev/dsp# links, not the /dev/oss/oss_envy24/ devices.
Are you aware of a way to do this?
dogbertwrldrulr wrote:The install on the second configuration was a clean install.
dogbertwrldrulr wrote:I know I am going to have to fix this, but I have no idea what the "Input/output error" is.
dogbertwrldrulr wrote:Im not sure what ALSO configs are, but I can check if you can point me in the general direction.
I only have inputs hooked up to the card at the moment, but if I try to use ossplay, no matter the length of the wav file I play, it returns immediately.
From my original post:
Also, if I run osstest, it skips all of the inputs and gives me "<left> OK <right> Device returned error: Input/output error
dogbertwrldrulr wrote:if I run osstest, it skips all of the inputs and gives me "<left> OK <right> Device returned error: Input/output error
Users browsing this forum: Bing [Bot], Google [Bot] and 3 guests