after this non success try:
i'm installing OSS on Solaris 10 8/07, without success again
I doesn't understand why loopback isn't available by default, and i'm searching on the net some docs about it. I found:
but nothing seems to be applicable to last release of OSS, does it?
If i did:
ultra20-henry% ossrecord -s48000 -b16 -c2 -d /dev/dsp0 test.wav
ultra20-henry% ossplay test.wav
i'm hearing nothing...
In vmix.conf, there are 8 entries:
and dev suggested that i set numloops to 1, but i don't know if it is related to a particular entry (vmix1, vmix2, etc...) or if numloops can be set to 2, 3, 4...
Where can i find the description of these variables?
what is the relation beetween these 8 parameters and what i see from ossinfo
ultra20-henry% ossinfo -v
Version info: OSS 4.0 (b1006/200708291218) (0x00040002)
Platform: SunOS/i86pc 5.10 Generic_120012-14 (ultra20)
Number of audio devices: 2
Number of audio engines: 7
/dev/oss/ich0/pcm0 Nvidia nForce4 (device index 0)
Legacy device /dev/dsp0
Caps: DUPLEX TRIGGER
Engine 1: Busy (IN/OUT) label 'VMIX'
Engine 2: Busy (IN/OUT) label 'gnome-settings-'
Engine 3: Available for use
Engine 4: Available for use
Engine 5: Available for use
Engine 6: Available for use
Why only 6 engines? Why Engine 1 and 2 are busy? Is it a problem when i want to record from loopback?
And again, OSS is ready to record from loopback device?
thanks in advance,